==========================================
Probe Basic Lathe Interface
==========================================

This page provides an overview of the Probe Basic Lathe interface tabs and their layout.

For detailed information about tool offset setup procedures and G7/G8 diameter/radius modes, see the :doc:`tool_offsets_lathe` documentation.

Main
----
.. image:: ../../images/lathe/01_Main.png
   :align: center

File
----
.. image:: ../../images/lathe/02_File.png
   :align: center

Offsets
-------
.. image:: ../../images/lathe/03_Offsets.png
   :align: center

The Offsets tab displays the current work coordinate system offsets. When Master Tool Offset Mode is enabled, this tab also includes the Master Tool Number field for tool promotion.

For detailed offset setup procedures, see :doc:`tool_offsets_lathe`.

Touch Off
---------
.. image:: ../../images/lathe/04_Touch_Off.png
   :align: center

The Touch Off tab provides tool offset setup functionality with intelligent G7/G8 mode detection. Button labels automatically change between "TOUCH X DIAM" and "TOUCH X RAD" based on the active diameter/radius mode.

For step-by-step tool offset procedures, see :doc:`tool_offsets_lathe`.

Tool Table
----------
.. image:: ../../images/lathe/05_Tool_Table.png
   :align: center

Probing
-------
.. image:: ../../images/lathe/06_Probing.png
   :align: center

Conversational
--------------
.. image:: ../../images/lathe/07_Conversational.png
   :align: center

Settings
--------
.. image:: ../../images/lathe/08_Settings.png
   :align: center

Status
------
.. image:: ../../images/lathe/09_Settings.png
   :align: center